Restraint
Passenger Airbag (PAB) Module Repair procedures
In this manual: Restraint
8steps
~48min
3/5difficulty
Done 0 of 8
Removal
Disconnect the battery negative terminal, and wait for at least three minutes before beginning to work.
Remove the glove box assembly.
(Refer to Body (Interior and Exterior) - "Glove box housing")
Remove the PAB mounting bolts.
Tightening torque: 8.8 - 10.8 N.m (0.9 - 1.1 kgf.m, 6.5 - 8.0 lb-ft)

Disconnect the passenger airbag connector (A).

Remove the main crash pad.
(Refer to Body (Interior and Exterior) - "Main crash pad assembly")
Loosen the Passenger airbag module mounting bolts (2) Remove the passenger airbag module.
Tightening torque: 3.9 - 5.9 N.m (0.4 - 0.6 kgf.m,2.8 - 4. 3 lb-ft)

Installation
Install in the reverse order of removal
After installing the airbag module, ensure that the airbag system is operating normally.
Was this page helpful?