Body Electrical System

Power Door Lock Module Repair procedures

12steps
~72min
3/5difficulty
Done 0 of 12

Inspection

Front Door Lock Module Inspection

  1. Remove the front door trim.

    (Refer to Body - "Front Door Trim")

  2. Remove the front door module.

    (Refer to Body - "Front Door Module")

  3. Disconnect the connector from the actuator.

    [Central Lock Motor]

    No. Pin Information
    LH RH
    1 - AJAR switch
    2 Motor 1 COM
    3 Motor 2 Lock / Unlock switch
    4 Key unlock switch Key lock switch
    5 Key lock switch Key unlock switch
    6 Lock / Unlock switch Motor 2
    7 COM Motor 1
    8 AJAR switch -

    [Dead Lock Motor]

    No. Pin Information
    LH RH
    1 Motor 1 AJAR switch
    2 Motor 2 COM
    3 Motor 3 Lock / Unlock switch
    4 Key unlock switch Key lock switch
    5 Key lock switch Key unlock switch
    6 Lock / Unlock switch Motor 3
    7 COM Motor 2
    8 AJAR switch Motor 1
  4. Check actuator operation by connecting power and ground as shown below. To prevent damage to the actuator, apply battery voltage only momentarily.

    [Central Lock Motor]

    [Dead Lock Motor]

    [Central Lock Motor]

    (LH)

    (RH)

    [Dead Lock Motor]

Rear Door Lock Module Inspection

  1. Remove the rear door trim.

    (Refer to Body - "Rear Door Trim")

  2. Remove the rear door module.

    (Refer to Body - "Rear Door Module")

  3. Disconnect the connector from the actuator.

    [Central Lock Motor]

    No. Pin Information
    LH RH
    1 - AJAR switch
    2 Motor 1 COM
    3 Motor 2 Lock / Unlock switch
    4 - -
    5 - -
    6 Lock / Unlock switch Motor 2
    7 COM Motor 1
    8 AJAR switch -

    [Dead Lock Motor]

    No. Pin Information
    LH RH
    1 Motor 1 AJAR switch
    2 Motor 2 COM
    3 Motor 3 Lock / Unlock switch
    4 - -
    5 - -
    6 Lock / Unlock switch Motor 3
    7 COM Motor 2
    8 AJAR switch Motor 1
  4. Check actuator operation by connecting power and ground as shown below. To prevent damage to the actuator, apply battery voltage only momentarily.

    [Central Lock Motor]

    [Dead Lock Motor]

    [Central Lock Motor]

    (LH)

    (RH)

    [Dead Lock Motor]

Tailgate Lock Module Inspection

  1. Remove the tailgate trim.

    (Refer to Body - "Tailgate Trim")

  2. Disconnect the connectors from the actuator.

  3. Check actuator operation by connecting power and ground as shown below. To prevent damage to the actuator, apply battery voltage only momentarily.

  4. Checking the tailgate of the vehicle power option power refers to the tailgate module.