Body Electrical System

Power Door Lock Switch Repair procedures

11steps
~66min
3/5difficulty
Done 0 of 11

Inspection

[Non-IMS Type]

  1. Check for continuity between the terminals. If there is an abnormality, replace the switch.

[IMS Type]

Diagnosis With KDS/GDS

  1. The body electrical system can be quickly diagnosed for failed parts by using vehicle diagnostic system (KDS/GDS).

    The diagnostic system (KDS/GDS) provides the following information.

    1. Self diagnosis : Checks and displays the failure code (DTC)

    2. Current data : Checks the system input/output data state

    3. Actuation test : Checks the system operating condition

    4. Additional function : Other controls such as the system option and zero point

  2. Select the 'Car model' and the system to be checked in order to check the vehicle with the tester.

  3. Select the 'Body Control Module (BCM)' to check the driver seat or assist door module (DDM/ADM).

  4. Select the "Current Data" menu to check the current state of the input/output data.

    The input/output data for the sensors corresponding to the driver seat or assist door module (DDM/ADM) can be checked.

  5. To check the power door lock operation by force, select "Actuation test".

Removal

  1. Disconnect the negative (-) battery terminal.

  2. Remove the front door trim.

    (Refer to Body - "Front Door Trim")

  3. Remove the power window switch assembly (A) after loosening the mounting screws.

Installation

  1. Install the power window switch assembly.

  2. Install the front door trim after connecting the connector.

  3. Connect the negative (-) battery terminal.