Body (Interior and Exterior)
Rear Bumper Cover Repair procedures
In this manual: Body (Interior and Exterior)
12steps
~72min
3/5difficulty
Done 0 of 12
Replacement
Remove the combination lamp cover (A).

Remove the rear combination lamp (A) after loosening the mounting screws.

Remove the waterproof seal (A).

Disconnect the rear combination lamp connector (A).

Loosen the rear bumper upper mounting fastener.

Remove the rear bumper side after loosening the screw and fastener.

Remove the wheel guard mounting clip (A).

Remove the rear bumper side under cover (A).
[LH]

[RH]

Loosen the mounting bolts.

Disconnect the rear bumper main connector (A).

Remove the rear bumper cover (A).

Install in the reverse order of removal.
Was this page helpful?