Driveshaft and axle

Repair procedures

16steps
~101min
5/5difficulty
1special tools
04080120160200127.594N·mlb·ft
Tightening torque found on this page
Done 0 of 16

Removal

  1. Remove the wheel and tire.

    Tightening torque : 107.9 - 128 N·m

  2. By hammering on a chisel, unlock the driveshaft lock hub nut caulking.

  3. Remove the caulking nut (A) from the front axle.

    Tightening torque : 274.6 - 294 N·m

  4. Remove the front caliper.

    (Refer to Brake System - "Front disck brake")

  5. Remove the wheel speed sensor bolt (A).

    Tightening torque : 6.8 - 10,7 N·m

  6. Remove the tie rod end pin (A) and nub (B).

    Tightening torque : 78.4 - 98 N·m

  7. Remove the knuckle by using the SST (09568-34000).

  8. Loosen the pin (A), and then remove the lower arm nut (B).

    Tightening torque : 98.0 - 118 N·m

  9. Loosen the strut bolt and then remove the front axle.

    Tightening torque : 156.9 - 176 N·m

Disassembly

  1. Loosen the screw, and then remove the brake disc.

    Tightening torque : 4.9 - 5,8 N·m

  2. Remove the hub assembly mounting bolts from the knuckle.

    Tightening torque : 88.2 - 108 N·m

  3. Loosen the dust cover bolts and then remove the dust cover.

    Tightening torque : 6.8 - 10,7 N·m

Inspection

  1. Check the hub for cracks and the splines for wear.

  2. Check the brake disc for scoring and damage.

  3. Check the knuckle for cracks

  4. Check the bearing for cracks or damage.