Service Highlight

Repair procedures

17steps
~102min
5/5difficulty
0102030405013.710N·mlb·ft
Tightening torque found on this page
Done 0 of 17

Removal

Hybrid Power Control Unit (HPCU)

  1. Shut off the high voltage circuit.

    (Refer to Hybrid Control System - “High Voltage Shutoff Procedure”)

  2. Remove the air cleaner assembly and air duct.

    (Refer to Engine Mechanical System - "Air Cleaner")

  3. Remove the ECM & TCM bracket assembly.

    (Refer to Engine Control/Fuel System - "Engine Control Module")

  4. Drain the coolant of hybrid motor cooling system.

    (Refer to Hybrid Motor Cooling System - "Coolant")

  5. Remove the HPCU protector (A) after loosening the mounting bolts.

  6. Disconnect the motor power cable connector (A) and HSG power cable conector (B).

  7. Disconnect the power cable (A) [↔ High voltage battery system assembly] and power cable (B) [↔ HSG & Electric A/C compressor].

  8. Disconnect the HCU & inverter (MCU) connector (A).

  9. Disconnect the coolant outlet hose & pipe (A) after loosening the mounting bolt.

  10. Disconnect the LDC power output cable (A) and LDC ground (-) cable (C) after loosening the mounting bolt and nut.

    LDC power (12V) output cable mounting nut :

    10.8 - 13,7 N·m

    LDC ground cable mounting bolt :

    7.8 - 11,8 N·m

  11. Remove the HPCU (B) after looening the mounting bolts.

    HPCU mounting bolt : 21.6 - 24 N·m

  12. Remove the coolant hose & pipe (A) from the HPCU.

  13. Remove the reservoir (B) after loosening the mounting bolts.

    Reservoir mounting bolt : 3.9 - 5,9 N·m

Hybrid Power Control Unit (HPCU) Tray

  1. Remove the hybrid power control unit.

    (Refer to Hybrid Control System - "Hybrid Power Control Unit (HPCU)")

  2. Remove the hybrid power control unit tray (A) after loosening the mounting bolts.

    Hybrid Power Control Unit (HPCU) tray mounting bolt :

    21.6 - 24 N·m

Installation

  1. Install the LDC in the reverse order of removal.

  2. Refill the hybrid motor cooling system coolant and perform air bleeding by using the KDS/GDS.

    (refer to Hybrid Motor Cooling System - "Coolant")