Service Highlight
Resolver Sensor Repair procedures
In this manual: Service Highlight
4steps
~24min
2/5difficulty
Done 0 of 4
Inspection
Hybrid Drive Motor
Inspect the resolver sensor resistance.
Item Pin Specification Remarks Resistance
(Resolver sensor)1 - 5 11.7 Ω ± 10 % At room temperature 68°F (20°C) 2 - 6 34.5 Ω ± 10 % 3 - 7 29.5 Ω ± 10 %

If the resolver sensor need to be replaced, hybrid drive motor assembly should be replaced.
(Refer to Hybrid Motor Assembly - "Hybrid Drive Motor Assembly")
Hybrid Starter Generator (HSG)
Inspect the resolver sensor resistance.
Item Pin Specification Remarks Resistance
(Resolver sensor)1 - 4 13.8 - 17.8 Ω At room temperature 68°F (20°C) 2 - 5 26.2 - 30.2 Ω 3 - 6 26.2 - 30.2 Ω

If the resolver sensor need to be replaced, HSG assembly should be replaced.
(Refer to Hybrid Motor Assembly - "Hybrid Starter Generator")
Resolver Calibration
Perform the resolver calibration using the KDS / GDS after replacing or reinstalling the below components.
Hybrid Drive Motor installation
Hybrid Starter Generator (HSG) installation
Motor Control Unit (MCU) replacement
Engine clutch system replacement

Was this page helpful?