TPMS Receiver Repair procedures
Removal
Disconnect the battery negative cable.
Remove the glove box.
(Refer to Body - "Glove Box Housing")
Disconnect the blower motor connector (A).

Disconnect the body control module (BCM) connector (A).

Loosen the body control module bolt and nut.


Disconnect the connector and then remove the body control module.

Install in the reverse order of removal.
Diagnosis procedure by using diagnostic device
The main contents of diagnostic method using diagnostic device are as follows:
Connect self-diagnosis connector (16 pins) located in the lower driver side crash pad to self-diagnostic device, and then turn on the self-diagnostic device after key is ON.
Select the "vehicle model" and "TPMS" on KDS/GDS vehicle selection screen, then select OK.
[Vehicle Name Writing Method 1]

[Vehicle Name Writing Method 2]

[Vehicle Name Writing Method 3]

[Wheel Sensor ID Writing Method 1]

[Wheel Sensor ID Writing Method 2]

[Wheel Sensor ID Writing Method 3]

[Wheel Sensor ID Writing Method 4]
