Battery Repair Procedures

Inspection

Battery Voltage and Condition Check the battery voltage and condition with a battery tester. Battery Terminal

1. 1
   Move the battery terminal clamp (A) back and forth to check that the battery terminals are not loose or corroded. If the terminals are corroded, clean them.

   

   If the positive battery terminal is loose, disconnect the ground (GND) cable before attempting to remove or tighten the positive connection to prevent injury.

2. 2
   If the battery clamp on the positive (+) battery terminal is loose:

   1. Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
   2. Tighten the battery clamp (A) on the positive (+) battery terminal. Positive (+) battery terminal: 7.8 ~ 9.8 N·m

      

3. 3
   If the battery clamp on the negative (-) battery terminal is loose:

   1. Tighten the battery clamp (A) on the negative (-) battery terminal. Negative (-) battery terminal: 4.0 ~ 6 N·m

      

Battery Condition: Inspect the battery for damage or deformation. If severe damage, deformation or leakage is found, replace the battery.