Quiz: how well do you know your Kia Soul EV Owner's Manual?

20 questions. After each answer you get a short explanation and a link to the manual page that covers it in detail.

Kia Soul EV: after how many miles should the reduction gear oil be replaced if the car is used under severe conditions?
120,000 miles. Under normal use the gear oil needs no replacement; under severe use (rough roads, mountains, taxi, towing, etc.) change it at 120,000 miles. Always fit a new gasket on the drain plug. Reduction Gear Oil Repair Procedures

Soul EV front hub removal: what is the tightening torque of the driveshaft nut?
274.6–294 N·m. The driveshaft lock nut is tightened to 274.6–294 N·m and must be replaced with a new one, then staked with a chisel and hammer. Front Hub/Steering Knuckle Repair Procedures

With the driver's auto-up window safety function, what force makes the window reverse while closing?
100 N or more. If 100 N or more is detected, the window reverses and lowers. The safety function does not work within 4 mm of the top of the door. Description and Operation

What is the specified total front toe for the Soul EV?
0.1° ± 0.2°. Total toe is 0.1° ± 0.2°, adjusted by turning left and right tie rods by the same amount. Camber and caster are factory-set and not adjustable. Wheel Alignment Repair Procedures

Which Flex Steer mode is meant mainly for highway driving?
Sport. Sport suits highway driving; Comfort is lighter and meant for city driving and parking; Normal is the base mode. Mode info shows in the cluster for 4 seconds. Flex Steer Description and Operation

When can the electric parking brake (EPB) be released using the switch while stationary?
Ignition on and brake pedal pressed. For safety, static release works only with ignition on and the brake pedal pressed. On slopes under 8% the clamp force is reduced when applied. Electric Parking Brake (EPB) Description and Operation

If a Soul EV can't go on a flatbed, what is the recommended maximum towing distance and speed?
30 km at under 50 km/h. Towing with drive wheels lifted is limited to 30 km at under 50 km/h. Before that, start the car, shift D then N and switch off. Never lift by the bumpers. General Information

After installing a side airbag, what should the SRS indicator do when ignition is switched on?
Light about six seconds, then go out. A correct installation shows the SRS lamp on for about six seconds, then off. Also disconnect the battery negative cable and wait 30 seconds before work. Repair Procedures of Side Airbag (SAB) Module

After removing the safety plug on the Soul EV, the voltage between high-voltage terminals must be below what value?
30 V. Verify voltage is below 30 V after removing the safety plug. All high-voltage wiring and connectors are orange. Also avoid paint-booth heat above 70 °C/30 min. General Safety Information and Precautions

What is the service limit for front brake pad thickness on the Soul EV?
2.0 mm. Pads are 10.5 mm new and must be replaced at 2.0 mm. Front disc service limit is 21 mm (standard 23 mm). Disc Brake Pads and Disc Repair Procedures

Before replacing rear brake pads on the Soul EV, what must be done with the EPB?
Use GDS pad change mode. Connect GDS and run the 'PAD change mode' procedure before and after pad replacement. The piston is pushed back with SST 09580-0U000. Rear disc brake repair procedures

How long does the airbag warning lamp light when ignition is switched on during the normal self-check?
6 seconds. The lamp is on 6 seconds during initialization, then off. If there is an active fault it flashes for 6 seconds and then goes off for 1 second. Description and Operation

If battery electrolyte gets in your eyes, how long should you rinse them with clean water?
At least 15 minutes. Rinse eyes at least 15 minutes and get medical help immediately. Hydrogen is always present in battery cells and can explode. General Information

After ignition on, the steering feels heavier for about how long while EPS runs diagnostics?
About 2 seconds. Heavier steering for about 2 seconds after ignition is normal if the EPS lamp is off. Relay clicks and motor noise at low speed are normal too. Repair Procedures

Where is the Soul EV main relay installed?
In the power relay assembly (PRA). The main relay sits in the PRA and connects HV battery power to the junction box on a BMS ECU signal. It is not controlled if a cell swells from overcharge. Main Relay Description and Operation

When removing the panoramic roof roller blind, how much of it should be left unopened?
10–20 cm. Open the blind with the switch but leave 10–20 cm. Beware of hand injury when side bracket tension is released. Sunshade Repair Procedures

Before replacing the PWM fan module, what must you disconnect first?
Battery negative terminal. Disconnect the battery negative terminal, then remove the glove box housing to reach the fan resistor and connector. PWM Blower Module Repair Procedures

What is the main benefit of the Soul EV heat pump?
Less battery use for heating, longer range. The heat pump minimizes heater battery consumption, extending range. It uses a chiller to recover waste heat from the motor. Description and Operation

After replacing a front door latch, what should you check?
Locking, unlocking, opening and closing work correctly. Verify connectors are properly connected and door locks/unlocks and opens/closes correctly. Replace any damaged clips. Front Door Latch Repair Procedures

How are FATC self-diagnosis fault codes shown on the display?
Two-digit code flashing at set temperature after three flashes. After the display flashes three times at 0.5 s intervals, the fault code blinks in the set temperature area as two digits. Heater and Air Conditioning Control Unit (FATC) Repair Procedures

← Back to the manuals