Rear Wiper Motor Repair Procedures

Inspection

1. 1
   Disconnect the connector from the rear wiper motor.
2. 2
   Connect the battery positive (+) and negative (-) cables to terminals 2 and 1, respectively.
3. 3
   Check that the motor operates normally. Replace the motor if it operates abnormally.

   No.	Description
   1	Battery (+)
   2	Parking
   3	Ground
   4	Signal

   
   

   

   

4. 4
   Operate the motor at low speed using the wiper switch on the steering column.
5. 5
   Stop the motor at any position other than OFF by disconnecting terminal 2.
6. 6
   Connect the positive (+) battery cable to terminal 2 and the negative (-) cable to terminal 1.
7. 7
   Check that the motor stops in the OFF position.

   

Removal

1. 1
   Remove the rear wiper cover (A).

   

2. 2
   Remove the rear wiper arm and blade (B) after removing the rear wiper hex nut (A).

   

   

3. 3
   Remove the rear wiper grommet (A).

   

4. 4
   Remove the luggage door trim after opening the luggage door. (Refer to Body - "Rear Door Trim")
5. 5
   Disconnect the rear wiper motor connector (A), then remove the rear wiper motor (B) after loosening the bolts.

   

   

Installation

1. 1
   Install the rear wiper motor assembly.

   Bolt Tightening Torque: 6.9~10.8 N·m

2. 2
   Install the liftgate trim.
3. 3
   Install the rear wiper arm cover after tightening the nut.

   Nut Tightening Torque: 3.9~6.9 N·m

4. 4
   Install the rear wiper blade and the lower defogger line and rear door glass. A: Auto Stop Position