Kia Cee'd Quiz
Engine Electrical System

Cruise Control Switch Repair Procedures

In this manual: Engine Electrical System
General Information — 15Maintenance — 7Engine Mechanical System — 84Engine Electrical System — 49Emission Control System — 22Fuel System — 95Clutch System — 28Manual Transmission — 21Dual Clutch Transmission (DCT) System — 47Drive Shaft and Axle — 20Suspension System — 36Steering — 23Restraints — 39Brake System — 54Body (Interior and Exterior) — 209Body Electrical System — 254Heating, Ventilation, and Air Conditioning — 56
9steps
~54min
2/5difficulty
Done 0 of 9

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the airbag module from the steering wheel. (Refer to Restraint System - Driver Airbag Module (DAB) and Clock Spring)
  3. Remove the steering wheel. (Refer to Steering System - "Steering Wheel")
  4. Remove the steering wheel cover (A) after loosening the screws.
  5. Disconnect the cruise control switch connector (A).
  6. Remove the cruise control switch (A) by removing the screws.

Installation

  1. Install in the reverse order of removal.

Inspection

Resistance Measurement

  1. Disconnect the cruise control switch connector from the control switch.
  2. Measure the resistance between the terminals of the control switch when each function switch is ON (switch pressed).
    Function Switch Terminal Resistance (+5%)
    CANCEL 2 - 7 180 Ω
    SET 2 - 7 330 Ω
    RESUME 2 - 7 550 Ω
    CRUISE 2 - 7 880 Ω
    S/LIMIT 2 - 7 1.44 kΩ
    Flexible steering wheel 4 - 7 180 Ω
  3. If not within specification, replace the switch.

Test yourself

A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.