Body Electrical System
Sunroof Motor Repair Procedures
In this manual: Body Electrical System
6steps
~36min
2/5difficulty
Done 0 of 6
Inspection
- Disconnect the negative (-) battery terminal.
- Remove the roof trim assembly. (Refer to Body - "Roof Trim Assembly")
- Disconnect the connector (A).
- Remove the sunroof motor (B) by removing the 3 bolts.

- Ground the terminals as shown in the table below and verify that the sunroof assembly operates.

- Perform these input tests at the connector. If any test indicates a problem, locate and repair the cause, then recheck the system. If all input tests show the sunroof motor is faulty, replace it.
Terminal Test
ConditionTest: Expected Result 3 IG2 ON Check voltage to ground:
Battery voltage should be present.1 Under any condition Check continuity to ground:
Continuity should be present.6 Under any condition Check voltage to ground:
Battery voltage should be present.
Test yourself
A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?