Repair Procedures

Adjustment

1. 1
   Remove the front door trim. (Refer to Front Door - "Front Door Trim")
2. 2
   Remove the front door glass mounting hole plug (B).
3. 3
   Carefully slide the front door glass (A) until the glass mounting bolts are visible, then loosen them.

   

4. 4
   Make sure the glass moves smoothly.

1. 1
   Loosen the screws (B) just enough to allow the latch to move.

   Tightening Torque: (B): 16.7 ~ 22 N·m

   

2. 2
   Tap the striker with a plastic hammer to adjust it. The striker will not move much, but will allow some adjustment.
3. 3
   While holding the outside handle, press the door against the body to make sure the striker allows flush fitting. If the door latched correctly, tighten the screws and recheck.

1. 1
   Make sure the door and body edges are parallel.

   

2. 2
   When adjusting the doors, place the vehicle on a hard, level surface.
3. 3
   Adjust at the hinges (A):

   • Slightly loosen the door mounting bolts and move the door inward or outward until it is level with the body.
   • Slightly loosen the hinge mounting bolts and move the door rearward or forward, up or down as necessary to align the gaps.
   • Place a shop towel on the jack to avoid damaging the door when adjusting the door.

   Tightening torque: (B): 21.6 ~ 26 N·m (C): 33.3 ~ 41 N·m

   

4. 4
   Lubricate the moving parts of the specified hinges.
5. 5
   Check for water leaks.