Repair Procedures

Adjustment

1. 1
   Check for abnormal noise or binding during operation.
2. 2
   With the sunroof fully closed, check for water leaks.
3. 3
   The roof panel (B) must be flush with the sliding glass seal (A) within the standard value "E" around the entire perimeter. If not, make adjustments. Tightening torque: Standard value "E" [mm (in)] (1) Front edge: 1.2 mm (0.0472 in) (2) Rear edge: 1.0 mm (0.0394 in)

   

4. 4
   If the position does not conform to the specification, slightly loosen the glass height adjusting screws (A), adjust the height, and tighten them.[Front]

   

   [Rear]

   

5. 5
   Use the panoramic roof emergency handle to close and open the panoramic roof manually only in the following case.

   • To close the panoramic roof before driving the vehicle in rain or on the highway, when the panoramic roof cannot be closed due to a failure of the panoramic roof motor or controller.
6. 6
   Operation Method

   • Remove the headliner.
   • Insert the emergency handle upward into the hexagonal drive of the panoramic roof motor. You must push firmly enough to disengage the motor clutch; otherwise the emergency handle will slip out due to incomplete engagement with the motor.
   • Carefully turn the emergency handle clockwise to close the sunroof.
   • After closing the sunroof, move the handle back and forth. When removing the tool from the motor, make sure the motor clutch re-engages.
   • Instead of the emergency handle, a 5 mm hex key with a speeder-type handle may be used.