Kia Cee'd Quiz
Body Electrical System

Repair Procedures

In this manual: Body Electrical System
General Information — 15Maintenance — 7Engine Mechanical System — 84Engine Electrical System — 49Emission Control System — 22Fuel System — 95Clutch System — 28Manual Transmission — 21Dual Clutch Transmission (DCT) System — 47Drive Shaft and Axle — 20Suspension System — 36Steering — 23Restraints — 39Brake System — 54Body (Interior and Exterior) — 209Body Electrical System — 254Heating, Ventilation, and Air Conditioning — 56
15steps
~90min
4/5difficulty
Done 0 of 15

Inspection

Inspection of the Light Switch. With the multifunction switch in each position, make sure there is continuity between the terminals below. If continuity is not as specified, replace the multifunction switch.
Light Switch (Automatic Lighting)
Light Switch
Dimmer and Passing Switch
HU: High Beam HL: Low Beam P: Headlight Switch Turn Signal Switch
Rear Fog Lamp
Front and Rear Fog Lights
Inspection of the Wiper and Washer Switch. With the multifunction switch in each position, make sure there is continuity between the terminals below. If continuity is not as specified, replace the multifunction switch.
Wiper Switch
Washer Switch
Rear Wiper Switch
Rear washer switch

Inspection (with GDS)

  1. Check the BCM input/output specifications of the multifunction switch using GDS. If the specifications are not within the standard, replace the lamp or wiper switch.
  2. If diagnosis of the multifunction switch is required, select the model and "BCM".
  3. To view the BCM input/output current values, select "Current DATA". This provides information on the BCM power supply input/output conditions, turn signal/stop lamp, headlamp, door, locks, outside mirror, wiper, auto light, and transmitters, etc.
  4. To perform a forced operation on the BCM input factors, select "ACTUATION TEST".

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the steering wheel. (Refer to Steering System - "Steering Wheel")
  3. Remove the lower/upper steering column shroud panel. (Refer to Body - "Steering Column Shroud Panel")
  4. Remove the clock spring. (Refer to Restraint System - Driver Airbag (DAB) and Clock Spring)
  5. Disconnect the light switch connector (A) and the wiper and washer switch connector (B).
  6. If it is necessary to remove only the wiper and washer switch (A), release the wiper switch lock using a tool without removing the steering wheel and clock spring.
  7. Remove the multifunction switch assembly (A) after loosening the 2 screws.

Installation

  1. Install the multifunction switch.
  2. Install the clock spring.
  3. Install the upper and lower steering column covers.
  4. Install the steering wheel.

Test yourself

A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.