Kia Cee'd Quiz
Body Electrical System

Repair Procedures

In this manual: Body Electrical System
General Information — 15Maintenance — 7Engine Mechanical System — 84Engine Electrical System — 49Emission Control System — 22Fuel System — 95Clutch System — 28Manual Transmission — 21Dual Clutch Transmission (DCT) System — 47Drive Shaft and Axle — 20Suspension System — 36Steering — 23Restraints — 39Brake System — 54Body (Interior and Exterior) — 209Body Electrical System — 254Heating, Ventilation, and Air Conditioning — 56
12steps
~72min
3/5difficulty
Done 0 of 12

Inspection

Check it by performing the procedure below to verify that the ECM is operating normally.
  1. Turn the ignition switch to the "ON" position.
  2. Cover the front sensor to disable it.
  3. Shine a flashlight on the rear sensor.
  4. The ECM should dim as soon as the rear sensor detects light.
  5. When the reverse gear is engaged, the ECM should not dim.
  6. When light is directed at both the front and rear sensors, the ECM should not darken.

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the mirror wiring cover (B) and disconnect the connector (A).
  3. Remove the mounting screw (A).
  4. Slide the inside rearview mirror rearward to remove the inside rearview mirror assembly (B).

Installation

  1. Install the mirror assembly.
  2. Install the mirror wiring cover and connector.

Test yourself

A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.