Kia Cee'd Quiz
Body Electrical System

Repair Procedures

In this manual: Body Electrical System
General Information — 15Maintenance — 7Engine Mechanical System — 84Engine Electrical System — 49Emission Control System — 22Fuel System — 95Clutch System — 28Manual Transmission — 21Dual Clutch Transmission (DCT) System — 47Drive Shaft and Axle — 20Suspension System — 36Steering — 23Restraints — 39Brake System — 54Body (Interior and Exterior) — 209Body Electrical System — 254Heating, Ventilation, and Air Conditioning — 56
19steps
~114min
4/5difficulty
Done 0 of 19

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the driver airbag lower panel. (Refer to Body - "Crash Pad Lower Panel")
  3. Remove the upper and lower steering column covers. (Refer to Body - "Steering Column Shroud Panel")
  4. Remove the wiper switch. (Refer to Multifunction Switch - "Multifunction Switch")
  5. Remove the ignition lock after disconnecting the ignition lock 6P connector (A).
  6. Disconnect the key warning/immobilizer connector (A).
  7. Remove the key warning sensor and key illumination (B) by loosening the screw.
  8. Press the stopper pin (A) in using the ACC key.
  9. Remove the key cylinder (A). B: Key warning switch and illumination C: Ignition lock connector

Installation

  1. Install the key cylinder lock.
  2. Install the key warning switch and key illumination.
  3. Connect the key warning/immobilizer connector.
  4. Connect the ignition lock connector after installing the ignition lock.
  5. Install the wiper switch.
  6. Install the steering column covers.
  7. Install the lower driver's airbag panel.

Inspection

  1. Disconnect the ignition switch connector (B) and key warning connector (A) from the steering column.
  2. Check the circuit between the terminals for continuity.
  3. If continuity is not as specified, replace the switch.

Test yourself

A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.