Body Electrical System
Speaker Repair Procedures
In this manual: Body Electrical System
16steps
~96min
4/5difficulty
Done 0 of 16
Inspection
- Speaker Troubleshooting
- Basic Speaker Inspection: Check the sound from the speaker with the speaker mounting screws removed and the wiring connector connected to eliminate possible vibrations transmitted from the body trim and surrounding parts.

- Troubleshooting
No. Symptom Inspection/Remedy 1 Rattling Noise - Before replacing the speaker, make sure the mounting screw is installed properly.
- After reinstalling the speaker, make sure that no rattling sound is heard.
- If the rattling sound is heard again, replace the speaker with a new one.
2 Noise - Check whether the wiring connector is connected properly. If not, connect the wiring connector.
- In case of radio static discharge, check for noise from the CD.
- If noise is heard with the radio and CD on, replace the speaker with a new one.
3 Speaker
Operating conditionCheck the wiring connection between the battery and speaker - Before replacing a speaker, inspect the wiring connection between the battery and the speaker for normal condition.
- Check the speaker power supply and resistance, then check the sound quality. ■ Specified resistance: 4.0 ± 0.6 Ω

- If the speaker performs poorly, replace it with a new one.
- Basic Speaker Inspection: Check the sound from the speaker with the speaker mounting screws removed and the wiring connector connected to eliminate possible vibrations transmitted from the body trim and surrounding parts.
Removal
Front Speaker- Remove the front door trim panel. (Refer to Body - "Front Door Trim")
- Remove the front speaker (A) after loosening the 4 clips.

[5 Door]
- Remove the rear door trim panel. (Refer to Body - "Rear Door Trim")
- Remove the rear speaker (A) after removing the 4 rivets.

[3-Door]
- Remove the center pillar trim. (Refer to Body - Center Pillar Trim)
- Remove the rear speaker assembly (A) after loosening the mounting bolts.

- Disconnect the connector (A) from the speaker.

- Remove the rear speaker (A) after loosening the mounting screws.

- Remove the speaker grille (A) from the protector panel.

- Remove the tweeter speaker (A) by removing 2 screws.

Installation
Front Speaker- Install the front speaker.
- Install the front door trim panel.
- Install the rear speaker.
- Install the rear door trim panel.
- Connect the connector.
- Install the tweeter speaker and speaker grille.
Test yourself
A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?