Cruise Control Switch Inspection [Mzr 2.0, Mzr 2.5]

1. Remove the battery cover..

2. Disconnect the negative battery cable and wait for 1 min or more

..

3. Remove the driver–side air bag module..

4. Disconnect the clock spring connector (part wiring harness-side).

5. Measure the resistance between clock spring terminals K and M (part wiring harness-side) using a tester.

• If not as specified, replace the steering switch..

Switch condition	Resistance (ohm)
Cruise OFF switch held at on	Continuity
CANCEL switch held at on	Approx. 120
SET (-) switch held at on	Approx. 300
SET (+) switch held at on	Approx. 600
RESUME switch held at on	Approx. 1,110
Cruise ON switch held at on	Approx. 2,110
Neutral	Approx. 4,310

6. Apply battery positive voltage to clock spring connector terminal O (part wiring harness-side), and terminal E (part wiring harness-side) to ground.

7. Verify that the LED illuminates.

• If the LED does not illuminate, replace the steering switch..