Mazda 6 Quiz
Braking system

Dsc hu/cm removal/installation

In this manual: Braking system
General information — 42Engine — 23Lubrication system — 10Cooling system — 9Fuel and emission control systems — 161Engine electrical system — 17Clutch — 21Manual transaxle — 10Automatic transaxle — 110Front and rear axles — 20Steering system — 15Braking system — 104Suspension — 34Body — 201Body electrical system — 287Heater and air conditioner systems — 89Technical data — 1Special tools — 1
~1min read
Caution
  • When replacing the DSC HU/CM, configuration procedure must be done before removing the DSC HU/CM. If configuration is not completed before removing the DSC HU/CM, DTC B2477 will be detected.
  • Do not drop the DSC HU/CM. Replace it if it is subjected to an impact.

1. Configurate the DSC HU/CM (when only replacing it).(See ABS (ABS/TCS) or DSC HU/CM CONFIGURATION.)

2. Remove the battery, battery tray and battery tray bracket.(See BATTERY REMOVAL/INSTALLATION.)

3. Remove the under cover.

4. Remove in the order indicated in the table.

5. Install in the reverse order of removal.



Connector Removal Note

1. Rotate the lock lever 40° to the direction A, then push the lock lever to the direction B.

Caution
  • After rotated the lever 40° , do not push the lock lever to the direction C. The lock lever will be damaged.

2. Verify that the lock lever is completely returned.

3. Remove the harness side connector to the direction D.

DSC HU/CM and Bracket Removal/Installation Note

When removing/installing the DSC HU/CM from/to the vehicle, attach a strip of tape on the DSC HU/CM connector to prevent brake fluid from entering.

Connector Installation Note

1. Verify that the connection part and waterproof packing are free of foreign material, then connect the connector.

2. Verify that the lock lever is completely pushed in.

Test yourself

A quick Mazda 6 quiz: every answer comes with an explanation and a link to the manual page.