Mazda 6 Quiz
Suspension

Front stabilizer removal/installation

In this manual: Suspension
General information — 42Engine — 23Lubrication system — 10Cooling system — 9Fuel and emission control systems — 161Engine electrical system — 17Clutch — 21Manual transaxle — 10Automatic transaxle — 110Front and rear axles — 20Steering system — 15Braking system — 104Suspension — 34Body — 201Body electrical system — 287Heater and air conditioner systems — 89Technical data — 1Special tools — 1
~1min read

1. Remove the front crossmember component. (See FRONT CROSSMEMBER REMOVAL/INSTALLATION.)

2. Remove in the order indicated in the table.

3. Install in the reverse order of removal.

4. Adjust the headlight zeroset. (See HEADLIGHT ZEROSET.)

5. Inspect the front wheel alignment. (See FRONT WHEEL ALIGNMENT.)



Stabilizer Bracket Installation Note

1. Apply rubber grease to the inside surface of the stabilizer bushing.

2. Align the bushing with the inside of positioning plate on the stabilizer bar.

3. Install the stabilizer bracket.

Test yourself

A quick Mazda 6 quiz: every answer comes with an explanation and a link to the manual page.