Mazda 6 Quiz
Body

Rear beltline molding removal

In this manual: Body
General information — 42Engine — 23Lubrication system — 10Cooling system — 9Fuel and emission control systems — 161Engine electrical system — 17Clutch — 21Manual transaxle — 10Automatic transaxle — 110Front and rear axles — 20Steering system — 15Braking system — 104Suspension — 34Body — 201Body electrical system — 287Heater and air conditioner systems — 89Technical data — 1Special tools — 1
~1min read
Note
  • When removing the rear beltline molding, the clip may be damaged. If the clip is damaged, replace it with a new one.

1. Pull the A section upward and remove the clip.


2. Rotate the B section of the front beltline molding in direction (2), along the direction (1) shown in the figure and remove it from the body.

3. Pull the C section upward and remove the clip. Then remove the front beltline molding.

Test yourself

A quick Mazda 6 quiz: every answer comes with an explanation and a link to the manual page.