Body Exterior, Doors, Roof & Vehicle Security

Additional Service When Replacing Ecm

5steps
~30min
2/5difficulty
Done 0 of 5

Description

Performing the following procedure can automatically activate recommunication of ECM and Intelligent Key unit, but only when the ECM is replaced with a new one*. For details, refer to Work Procedure.

*: New one means a virgin ECM that has never been energized on-board.

(In this step, initialization procedure using CONSULT is not necessary)

The functions controlled by the ECM does not operate properly in case of reuse of the ECM from another vehicle.

Work Procedure

PERFORM ECM RECOMMUNICATING FUNCTION

  1. Install ECM.

  2. Contact backside of the registered Intelligent Key* to push-button ignition switch while push switch is pressed, then turn ignition switch ON.

    *: To perform this step, use the key that is used before performing ECM replacement.

  3. Maintain ignition switch in the ON position for at least 5 seconds.

  4. Ignition switch OFF.

  5. Check that the engine starts.

>>

GO TO 2.

PERFORM ADDITIONAL SERVICE WHEN REPLACING ECM

Refer to Description.

>>

END