Body Exterior, Doors, Roof & Vehicle Security
Engine Can Not Start
In this manual: Body Exterior, Doors, Roof & Vehicle Security
~1min read
Description
Engine does not start when push-button ignition switch is pressed.
SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS)
| Door lock operation (remote keyless entry) | Door lock operation (request switch of front/rear door) or trunk/back door open operation (opener switch of trunk/back door panel) | Engine started with push-button ignition switch operation (registered Intelligent Key is within the detection area of inside key antenna) | Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch) | Unlock operation when approaching the vehicle, lock operation when away from the vehicle (registered Intelligent Key is within the detection area of outside key antenna) |
|---|---|---|---|---|
| OK | OK | No start | No start | OK |
DIAGNOSIS PROCEDURE
Refer to Diagnosis Procedure.
Diagnosis Procedure
CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE
Check Intelligent Key system symptom table. Refer to Diagnosis Procedure.
>>GO TO 2.
PERFORM SELF-DIAGNOSIS RESULT
With CONSULT
Select “Self Diagnostic Result” mode of all systems, and check if DTC is detected.
Is DTC detected?
YES>>Perform the trouble diagnosis for the detected DTC.
NO>>GO TO 3.
CHECK PUSH-BUTTON IGNITION SWITCH
Check push-button ignition switch. Refer to Component Function Check.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Check intermittent incident. Refer to Intermittent Incident.
Was this page helpful?