Steering

Additional Service When Replacing Power Steering Control Module Control Unit

7steps
~42min
2/5difficulty
Done 0 of 7

Work Procedure

DESCRIPTION

When replacing the power steering control module, the procedures of AFTER REPLACEMENT must be performed.

AFTER REPLACEMENT

After replacing the power steering control module, the following items must be performed:

  • Power steering control module programming.

  • Power steering control module configuration.

  • Adjustment of steering angle sensor neutral position.

  • Steering torque calibration.

  • Rack end value reset.

WORK PROCEDURE

REPLACE POWER STEERING CONTROL MODULE

With CONSULT

  1. Select "Replace ECU" of "EPS/DIRECT ADAPTIVE STEERING 3".

  2. Perform writing vehicle specification to power steering control module according to "Replace ECU" in CONSULT Operation Manual.

  • Ignition switch: ON

  • Electric load: OFF

  • vehicle speed: 0 km/h

  • 12V battery voltage: 10.5 V or more

  • Steering angle : ±90 °or less

  • Steering wheel: Do not touch

>>

GO TO 2.

PERFORM NECESSARY WORK

  1. Perform adjustment of steering angle sensor neutral position. Refer to Work Procedure.

  2. Perform steering torque calibration. Refer to Work Procedure.

  3. Perform rack reset. Refer to Work Procedure.

  4. Perform self-diagnosis for “EPS/DIRECT ADAPTIVE STEERING 3”.

  5. Erase the memory of self-diagnosis results.

>>

End of work.