Diagnosis and Repair Workflow
Work Flow
DETAILED FLOW
INTERVIEW FROM THE CUSTOMER
Clarify customer complaints before inspection. First of all, perform an interview utilizing reproduce symptoms as well as fully understand it. Ask customer about his/her complaints carefully. Check symptoms by driving vehicle with customer, if necessary. Refer to Diagnostic Work Sheet.
>>GO TO 2.
CHECK SYMPTOM
Reproduce the symptom that is indicated by the customer, based on the information from the customer obtained by interview. Also check that the symptom is not caused by protection function. Refer to Protection Function.
>>GO TO 3.
PERFORM SELF-DIAGNOSIS
With CONSULT
Perform self-diagnosis.
Is any DTC detected?
YES>>Record or print DTC. GO TO 4.
NO>>GO TO 6.
RECHECK SYMPTOM
With CONSULT
Erase self diagnosis result for "EPS/DIRECT ADAPTIVE STEERING 3".
Pull the parking brake switch.
Ignition switch OFF.
Get out of the vehicle and close all doors.
Wait 65 seconds.
Start the engine.
Perform DTC confirmation procedures for the error detected system.
Is any DTC detected?
YES>>GO TO 5.
NO >>Check harness and connectors based on the information obtained by interview. Refer to Intermittent Incident.
REPAIR OR REPLACE ERROR-DETECTED PARTS
Repair or replace error-detected parts.
Reconnect part or connector after repairing or replacing.
When DTC is detected, erase self diagnosis result for "EPS/DIRECT ADAPTIVE STEERING 3".
GO TO 7.
IDENTIFY ERROR-DETECTED SYSTEM BY SYMPTOM DIAGNOSIS
Estimate error-detected system based on symptom diagnosis and perform inspection.
Can the error-detected system be identified?
YES>>GO TO 7.
NO >>Check harness and connectors based on the information obtained by interview. Refer to Intermittent Incident.
FINAL CHECK
With CONSULT
Check the reference value for power steering control module.
Recheck the symptom and check that symptom is not reproduced on the same conditions.
Is the symptom reproduced?
YES>>GO TO 3.
NO>>INSPECTION END
Diagnostic Work Sheet
Description
In some cases, multiple conditions that appear simultaneously may cause a DTC to be detected.
Interview sheet sample
| Interview sheet | |||||
|---|---|---|---|---|---|
| Customer name | MR/MS | Registration number | Initial year registration | ||
| vehicle type | VIN | ||||
| Storage date | Engine / Traction motor | Mileage | km (Mile) | ||
| Symptom | □The steering wheel position (center) is in the wrong position. | ||||
| □Warning lamp turns on. | |||||
| □Noise □Vibration | |||||
□Others ( ) |
|||||
| First occurrence | □Recently □Others ( ) | ||||
| Frequency of occurrence | □Always □Under a certain conditions of □Sometimes (time(s)/day) | ||||
| Climate conditions | □Irrelevant | ||||
| Weather | □Fine □Cloud □Rain □Snow □Others ( ) | ||||
| Temperature | □Hot □Warm □Cool □Cold □Temperature [Approx. °C (°F)] | ||||
| Relative humidity | □High □Moderate □Low | ||||
| Road conditions | □Urban area □Suburb area □High way □Mounting road (uphill or down hill) □Rough road |
||||
| Operation conditions, etc. | □Irrelevant □When engine starts □During idling □During driving □During acceleration □At constant speed driving □During deceleration □During cornering (right curve or left curve) □During steering |
||||
| Other conditions | |||||
Memo |
|||||