Body Exterior, Doors, Roof & Vehicle Security

Anti-Pinch Inspection

4steps
~24min
2/5difficulty
Done 0 of 4

Description

If any of the following operations are performed, the initialization is necessary for normal operation of anti-pinch function. Refer to Work Procedure.

  • When each power window motor replaced.

  • Power supply to the each power window motor is not cut off properly.

  • Removal and installation of regulator assembly.

  • Removal and installation of each power window motor from regulator assembly.

  • Operation of regulator assembly as an independent unit.

  • Removal and installation of door glass.

  • Removal and installation of door glass run.

Work Procedure

CHECK ANTI-PINCH FUNCTION

  1. Fully open the door glass.

  2. Place a piece of wood near fully closed position.

  3. Close door glass completely with AUTO UP.

  4. Check the following conditions.

    • Check that door glass lowers for 145 mm (5.71 in) without pinching piece of wood and stops.

    • Check that door glass does not rise when operating the power window main switch while lowering.

>>

END