Electrical & Power Control

Lan System. Can Gateway

14steps
~84min
4/5difficulty
Done 0 of 14

Additional Service When Replacing 8ch Can Gateway

Description

When replacing the 8CH gateway, perform "Procedure before replacing" and "Procedure after replacing". Refer to Work Procedure.

Work Procedure

BEFORE REPLACEMENT

Perform control unit information saving procedure before replacing 8CH CAN gateway

SAVING CONTROL UNIT INFORMATION

With CONSULT

  1. Ignition switch OFF.

  2. Reconnect all of the disconnected harness connector.

  3. Ignition switch ON.

  4. Select “Replace ECU” mode of “8ch CAN GATEWAY 2”.

  5. Follow the steps displayed in CONSULT.

>>

Replace 8CH CAN gateway. Refer to Removal & Installation.

AFTER REPLACEMENT

Perform following procedure after replacing the 8CH CAN gateway

  • Programming

  • C/U setting

  • Writing the control unit information

  • Register of vehicle identification number

  • 8CH CAN gateway and Intelligent Key unit pairing

PERFORM REPLACE ECU

With CONSULT

  1. Select “Replace ECU” mode of “8ch CAN GATEWAY 2”.

  2. Follow the steps displayed in CONSULT.

    • Ignition switch ON.

    • Turn OFF all of the electric load.

    • Never depress the brake pedal

    • Battery voltage must be between 12 to 13.5V (Check the battery voltage displayed on the CONSULT.)

>>

GO TO 2.

VIN REGISTRATION WRITING

With CONSULT

  1. Select “Work support” mode of “8ch CAN GATEWAY 2” using CONSULT.

  2. Select “WRITE VIN DATA”

  3. Follow the instruction displayed in CONSULT.

>>

GO TO 3.

PAIRING OF 8CH CAN GATEWAY AND INTELLIGENT KEY UNIT

With CONSULT

Select “Quick Maintenance” → “Immobilizer” → “CGW Replacement” and follow the instruction displayed in CONSULT.

>>

GO TO 4.

PERFORM THE SELF-DIAGNOSIS

With CONSULT

  1. Erase all self-diagnosis results using CONSULT.

  2. Ignition switch OFF, and leave the vehicle with the driver's side door open. and wait for 2 minutes or more.

  3. Ignition switch ON and wait for 62 seconds or more.

  4. Perform "All DTC result" using CONSULT.

CAN communication DTCs detected?

YES>>

Perform trouble diagnosis procedure for CAN communication system. Refer to Trouble Diagnosis Flow Chart.

NO>>

INSPECTION END

8ch Can Gateway

Removal & Installation

REMOVAL

Remove instrument lower panel LH. Refer to Removal and Installation.

Remove front center console body assembly. Refer to Removal and Installation.

Remove center instrument lower panel. Refer to Removal and Installation.

Remove 8CH CAN gateway harness connectors .

Pull out 8CH CAN gateway from the steering member.

INSTALLATION

Install in the reverse order of removal.