Maintenance. Maintenance Procedures

Oil Filter

~2min read
0102030405017.713N·mlb·ft
Tightening torque found on this page

Removal and Installation

REMOVAL

Remove engine under cover using a power tool (commercial service tool). Refer to Removal and Installation.

Using oil filter wrench [SST: KV10115801 (NI-38956)] , remove oil filter .

: Engine front

INSTALLATION

Remove foreign materials adhering to oil filter installation surface.

Apply engine oil to the oil seal contact surface of new oil filter.

Screw oil filter manually until it touches the installation surface, then tighten it by 2/3 turn . Or tighten to the specification.

Oil filter:
: 17,7 N·m

Inspection

INSPECTION AFTER INSTALLATION

Check the engine oil level. Refer to Inspection.

Start the engine, and check there is no leak of engine oil.

Stop the engine and wait for 10 minutes.

Check the engine oil level, and adjust the level. Refer to Inspection.