Cruise Control & Driver Assistance
Power Network Separate Relay
In this manual: Cruise Control & Driver Assistance
~1min read
Exploded View

| Power network separate relay | Power network separate relay bracket | ||||
| : N·m (kg-m, ft-lb) | |||||
| : N·m (kg-m, in-lb) | |||||
Removal and Installation
REMOVAL
Disconnect the 12V battery cable from the negative terminal.
Remove 12V sub battery (lithium ion battery). Refer to Removal and Installation.
Check that there is no voltage (Approx. 0 V) between power network separate relay terminal
and ground and power network separate relay terminal
and ground.

Remove the power network separate relay terminal nuts![]()

Remove the power network separate relay bracket mounting bolts
, and remove the power network separate relay bracket
and power network separate relay bracket
.

Disconnect power network separate relay connector.
Push the lock
and remove the power network separate relay
from the bracket
.

INSTALLATION
Installation is in the reverse order of removal.
Was this page helpful?