Restraints

Zero Point Reset

5steps
~30min
2/5difficulty
Done 0 of 5

Description

Zero point reset is an initializing procedure for occupant detection system that must be performed when replacing occupant detection system control unit or removing and installing passenger seat.

If zero point reset is not performed, the initialization is incomplete and occupant detection system does not operate normally. Refer to Work Procedure.

Work Procedure

PERFORM ZERO POINT RESET

  1. Perform zero point reset.

    • Perform zero point reset after installing passenger seat to the vehicle

    • Never put any objects on passenger seat

    • Never apply excessive vibration to the vehicle

    • Never touch the vehicle

    • Never tilt the vehicle

  2. Select start on “Zero point reset function” screen from, WORK SUPPORT of CONSULT “OCCUPANT DETECTION”.

  3. “Zero point reset” starts.

>>

GO TO 2.

CONFIRMATION OF SETTING

  1. Proceed to “Zero point reset function” screen from work support of CONSULT “OCCUPANT DETECTION”.

  2. Check that “Already performed” or “Not yet performed” is displayed on “Zero point reset current status”.

Is condition “Already performed”?

YES>>

WORK END

NO>>

Check condition as per the following, and perform zero point reset again.

  • Passenger seat is occupied by an object.

  • Excessive vibration is applied while performing zero point reset.

  • Occupant detection system is malfunctioning.

  • Passenger seat is occupied by an object.

  • Excessive vibration is applied while performing zero point reset.

  • Occupant detection system is malfunctioning.