Additional service when removing battery negative terminal
• After removing the battery of the audio unit, the authentication of the anti-theft code is required.
Work Procedure 1.POWER SWITCH ON 1. Turn ignition switch ON.2. Turn ON the power switch of audio unit. (“CODE IN” is indicated on the display.) >> GO TO 2.
2.ANTI-THEFT CODE INPUT (FOUR-DIGIT CODE)1. Press the preset switch (using 1 to 4) to enter the code number.
Digit on the far-left : Preset switch 1 Digit on the second from left : Preset switch 2 Digit on the second from right : Preset switch 3 Digit on the far-right : Preset switch 4
2. The anti-theft code is authenticated by pressing preset switch “6”.
Is the anti-theft code authenticated ? YES >> END NO >> GO TO 3.
3.REENTER ANTI-THEFT CODE INPUT (FOUR-DIGIT CODE)1. When the input anti-theft code was not authenticated, anti-theft code input can be done up to 8 attempts, counting the below operation as an attempt.

CAUTION:
• If the attempts exceed 8, “system secure Please contact dealer” is displayed and anti-theft code input cannot be performed.
• The number of failed attempts is not reset and accumulated after any authentication.
2. Wait until anti-theft code entry screen is displayed.
>> GO TO 2.