Door & Lock type 4
Auto door lock operation does not operate
In this manual: Door & Lock type 4
~1min read
Diagnosis Procedure 1.CHECK “AUTO LOCK SET” SETTING WITH CONSULT-III 1. Select “MULTI REMOTE ENT” of “BCM” using CONSULT-III. 2. Select “AUTO LOCK SET” in “WORK SUPPORT” mode.
3. Check “AUTO LOCK SET” in “WORK SUPPORT”.
Refer to DLK-502, "MULTI REMOTE ENT : CONSULT-III Function (BCM - MULTI REMOTE ENT) (Without Super Lock)".
Is the inspection result normal? YES >> GO TO 2.
NO >> Set “AUTO LOCK SET” in “WORK SUPPORT”.
2.REPLACE BCM 1. Replace BCM. Refer to BCS-161, "Removal and Installation".2. Confirm the operation after replacement.
Is the result normal? YES >> INSPECTION END
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Was this page helpful?