Door & Lock type 4
Hazard reminder operation does not operate
In this manual: Door & Lock type 4
~1min read
Diagnosis Procedure 1.CHECK DTC WITH BCM AND COMBINATION METER
Check that DTC is not detected with BCM and combination meter.
Is the inspection result normal? YES >> GO TO 2.
NO-1 >> Refer to BCS-141, "DTC Index". (BCM) NO-2 >> Refer to MWI-36, "DTC Index". (Combination meter) 2.CHECK “HAZARD LAMP SET” SETTING IN “WORK SUPPORT”
1. Select “MULTI REMOTE ENT” of “BCM” using CONSULT-III. 2. Select “HAZARD LAMP SET” in “WORK SUPPORT” mode.3. Check “HAZARD LAMP SET” in “WORK SUPPORT”.
Refer to DLK-502, "MULTI REMOTE ENT : CONSULT-III Function (BCM - MULTI REMOTE ENT) (Without Super Lock)".
Is the inspection result normal? YES >> GO TO 3.
NO >> Set “HAZARD LAMP SET” in “WORK SUPPORT”.
3.CHECK HAZARD WARNING LAMPCheck hazard warning lamp.
Refer to DLK-525, "Component Function Check".
Is the inspection result normal? YES >> GO TO 4.
NO >> Repair or replace the malfunctioning parts.
4.REPLACE BCM 1. Replace BCM. Refer to BCS-161, "Removal and Installation".2. Confirm the operation after replacement.
Is the result normal? YES >> INSPECTION END
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Was this page helpful?