Power Control System IPDM E/R (without I-key)
B2098 ignition relay on stuck
In this manual: Power Control System IPDM E/R (without I-key)
~1min read
Description
The ignition relay integrated in IPDM E/R is operated with ignition switch ON signal from the ignition switch.
DTC Logic
DTC DETECTION LOGIC

1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON.
2. Check DTC in “Self Diagnostic Result” mode of “IPDM E/R” using CONSULT-III.
Is DTC detected? YES >> Refer to PCS-60, "Diagnosis Procedure".
NO >> INSPECTION END.
Diagnosis Procedure
1.CHECK IGNITION SWITCH ON SIGNALCheck voltage between BCM harness connectors and the ground.

Is the measurement value normal? YES >> Replace BCM. Refer to BCS-161, "Removal and Installation".
NO >> GO TO 2.
2.CHECK IGNITION SWITCH ON SIGNAL CIRCUIT 1. Turn the ignition switch OFF. 2. Disconnect IPDM E/R harness connectors.3. Check continuity between IPDM E/R harness connectors and BCM harness connectors.

Does continuity exist? YES >> Replace IPDM E/R. Refer to PCS-63, "Removal and Installation".
NO >> Repair the harness or connector.
Was this page helpful?