Power Control System IPDM E/R (without I-key)
B2099 ignition relay off stuck
In this manual: Power Control System IPDM E/R (without I-key)
~1min read
Description
The ignition relay integrated in IPDM E/R is operated with ignition switch ON signal from the ignition switch.
DTC Logic
DTC DETECTION LOGIC

NOTE
:
When IPDM E/R power supply voltage is low (Approx. 7 - 8 V for about 1 second), the “DTC: B2099” may be detected.
2. Check DTC in “Self Diagnostic Result” mode of “IPDM E/R” using CONSULT-III.
Is DTC detected? YES >> Refer to PCS-61, "Diagnosis Procedure".
NO >> INSPECTION END.
Diagnosis Procedure
1.CHECK IGNITION SWITCH ON SIGNAL CIRCUIT 1. Turn the ignition switch OFF. 2. Disconnect IPDM E/R harness connector and BCM harness connector.3. Check continuity between IPDM E/R harness connectors and BCM harness connectors.

Does continuity exist? YES >> Replace IPDM E/R. Refer to PCS-63, "Removal and Installation".
NO >> Repair the harness or connector.
Was this page helpful?