Body Control System Without intelligent key system
Combination switch input circuit
In this manual: Body Control System Without intelligent key system
~1min read
Diagnosis Procedure 1.CHECK INPUT 1 - 5 CIRCUIT FOR OPEN 1. Turn ignition switch OFF. 2. Disconnect BCM and combination switch connectors.


3. Check continuity between BCM harness connector and combination switch harness connector.

Does continuity exist? YES >> GO TO 2.
NO >> Repair harnesses or connectors.
2.CHECK INPUT 1 - 5 CIRCUIT FOR SHORTCheck for continuity between BCM harness connector and ground.

Does continuity exist? YES >> Repair harnesses or connectors.
NO >> GO TO 3.
3.CHECK BCM INPUT SIGNAL 1. Connect BCM and combination switch connectors. 2. Turn ON any switch in the system that is malfunction.3. Check voltage between BCM harness connector and ground.

Is the measurement value normal? Yes >> Replace BCM. Refer to BCS-161, "Removal and Installation".
No >> Replace combination switch.
Was this page helpful?