Body Control System Without intelligent key system
Power supply and ground circuit
In this manual: Body Control System Without intelligent key system
~1min read
Diagnosis Procedure 1.CHECK FUSES AND FUSIBLE LINK



Check that the following fuses and fusible link are not fusing.

Is the fuse fusing? YES >> Replace the blown fuse or fusible link after repairing the affected circuit if a fuse or fusible link is blown.
NO >> GO TO 2.
2.CHECK POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect BCM connectors.3. Check voltage between BCM harness connector and ground.

Is the measurement value normal? YES >> GO TO 3.
NO >> Repair harness or connector.
3.CHECK GROUND CIRCUITCheck continuity between BCM harness connector and ground.

Does continuity exist? YES >> INSPECTION END
NO >> Repair harness or connector.
Was this page helpful?