Heater & Air Conditioning Control System Type 1
Door motor starting position reset
In this manual: Heater & Air Conditioning Control System Type 1
~1min read
Description
• Reset signal is transmitted from A/C auto amp. to air mix door motor and mode door motor. Starting position reset can be performed.
NOTE:
During reset, DEF switch indicator blinks.
• When air mix door motor or mode door motor is removed and installed, always perform door motor starting position reset.
Work Procedure
1.PERFORM DOOR MOTOR STARTING POSITION RESET
With CONSULT-III
1. Turn ignition switch ON. 2. Select “Door Motor Starting Position Reset” in “ACTIVE TEST” mode of “HVAC” using CONSULT-III. 3. Touch “Start” and wait a few seconds.
4. Make sure the “COMPLETED” is displayed on CONSULT-III screen.
>> INSPECTION END
Was this page helpful?