Door request switch
Component Function Check
1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “REQ SW-DR”, “REQ SW-AS” in “DATA MONITOR” mode.3. Check that the function operates normally according to the following conditions.

Is the inspection result normal? YES >> Front door request switch is OK.
NO >> Refer to DLK-256, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK DOOR REQUEST SWITCH INPUT SIGNAL 1. Turn ignition switch OFF. 2. Disconnect malfunctioning front door request switch connector.3. Check voltage between malfunctioning front door request switch harness connector and ground.

Is the inspection result normal? YES >> GO TO 3.
NO >> GO TO 2.
2.CHECK DOOR REQUEST SWITCH CIRCUIT 1. Disconnect BCM connector.2. Check continuity between malfunctioning front door request switch harness connector and BCM harness connector.

3. Check continuity between malfunctioning front door request switch harness connector and ground.

Is the inspection result normal? YES >> Replace BCM. Refer to BCS-93, "Removal and Installation".
NO >> Repair or replace harness.
3.CHECK DOOR REQUEST SWITCH GROUND CIRCUITCheck continuity between malfunctioning front door request switch harness connector and ground.

Is the inspection result normal? YES >> GO TO 4.
NO >> Repair or replace harness.
4.CHECK DOOR REQUEST SWITCHRefer to DLK-257, "Component Inspection".
Is the inspection result normal? YES >> GO TO 5.
NO >> Replace malfunctioning front door request switch.
5.CHECK INTERMITTENT INCIDENTRefer to GI-42, "Intermittent Incident".
>> INSPECTION END
Component Inspection
1.CHECK DOOR REQUEST SWITCH 1. Turn ignition switch OFF. 2. Disconnect malfunctioning front door request switch connector.3. Check continuity between malfunctioning front door request switch terminals.

Is the inspection result normal? YES >> INSPECTION END
NO >> Replace malfunctioning front door request switch.