Door & Lock type 2
Shift P warning lamp
In this manual: Door & Lock type 2
~1min read
Component Function Check
1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “LCD” in “ACTIVE TEST” mode.3. Check that the function operates normally according to the following conditions.

Is the inspection result normal? YES >> Shift P warning lamp is OK.
NO >> Refer to DLK-269, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK SHIFT P WARNING LAMPRefer to MWI-22, "On Board Diagnosis Function".
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace the malfunctioning parts.
2.CHECK INTERMITTENT INCIDENTRefer to GI-42, "Intermittent Incident".
>> INSPECTION END
Was this page helpful?