Ecu diagnosis information
VALUES ON THE DIAGNOSIS TOOL
CONSULT-III MONITOR ITEM





TERMINAL LAYOUT

PHYSICAL VALUES


















• *1: With manual A/C • *2: RHD models
• *3: M/T models
• *4: LHD models
• *5: Except M/T models
FAIL-SAFE CONTROL BY DTC
BCM performs fail-safe control when any DTC are detected.



REAR WIPER MOTOR PROTECTION
BCM detects the rear wiper stopping position according to the rear wiper stop position signal.
When the rear wiper stop position signal does not change for more than 5 seconds while driving the rear wiper, BCM stops power supply to protect the rear wiper motor.
Condition of cancellation 1. More than 1 minute is passed after the rear wiper stop. 2. Turn rear wiper switch OFF.3. Operate the rear wiper switch or rear washer switch.
FAIL-SAFE CONTROL BY LIGHT AND RAIN SENSOR MALFUNCTION
BCM detects the light and rain sensor serial link error and the light and rain sensor malfunction.
BCM controls the following fail-safe when light and rain sensor has a malfunction.
Fail-safe Control• Auto light control: Headlamp low beam, parking lamp, license plate lamp and tail lamp are turned ON. • Front wiper control
- Front wiper switch AUTO and sensing rain drop: The condition just before the activation of fail-safe is maintained until the front wiper switch is turned OFF.
- Front wiper switch AUTO and not sensing rain drop: Front wiper is LO operation until the front wiper switch is turned off.
FAIL-SAFE CONTROL OF COMBINATION SWITCH READING FUNCTION CAUSED BY LOW POWER SUPPLY VOLTAGE
If voltage of battery power supply lower, BCM maintains combination switch reading to the status when input voltage is less than approximately 9 V.
NOTE:
When voltage of battery power supply is approximately 9 V or more, combination switch reading function returns to normal operation
If some DTCs are displayed at the same time, perform inspections one by one based on the following priority chart.


DTC Index NOTE
:
The details of time display are as follows.
• PAST: A malfunction was detected in the past.
IGN counter is displayed on Freeze Frame Data. For details of Freeze Frame Data, refer to BCS-17, "COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM)".



NOTE
:
• *1: With super lock
• *2: Without super lock