Fuel System MR16DDT
Evap canister
In this manual: Fuel System MR16DDT
~1min read
2WD : Hydraulic Layout
EVAPORATIVE EMISSION LINE DRAWING

1.EVAP canister purge volume control solenoid valve
2. EVAP canister
3. EAVP line
4. Fuel line
:
Do not use soapy water or any type of solvent while installing vacuum hose or purge hoses.
2WD : Removal and Installation
REMOVAL
1. Disconnect EVAP canister hoses. 2. Remove EVAP canister fixing bolt.3. Remove EVAP canister.
INSTALLATION
Install in the reverse order of removal.
NOTE:
Tighten EVAP canister fixing bolt to the specified torque.
4WD : Hydraulic Layout
EVAPORATIVE EMISSION LINE DRAWING

1. EVAP service port 2. EVAP canister
3. EVAP line
4. Fuel line
:
Do not use soapy water or any type of solvent while installing vacuum hose or purge hoses.
4WD : Removal and Installation
REMOVAL
1. Remove rear stabilizer (1). Refer to RSU-34, "Exploded View". 2. Disconnect EVAP canister hoses. 3. Remove EVAP canister fixing bolt.4. Remove EVAP canister (2).

INSTALLATION
Install in the reverse order of removal.
NOTE:
Tighten EVAP canister fixing bolt to the specified torque.
Was this page helpful?