Engine Cooling System MR16DDT
Flushing
In this manual: Engine Cooling System MR16DDT
~1min read
1. Install radiator drain plug.
CAUTION:Be sure to clean drain plug and install with new O-ring.
Radiator drain plug : Refer to CO-17, "Exploded View".
• If water drain plugs on cylinder block are removed, close and tighten them. Refer to EM-63, "Setting".
2. Remove air duct (between air cleaner cover assembly and turbocharger), air cleaner cover assembly and air cleaner body assembly. Refer to EM-26, "Exploded View".3. Disconnect vacuum hose break booster side, and remove vacuum tube from clamp. Refer to .
4. Disconnect heater hose (1) at position ( ) in the figure.
: Vehicle front
• Enhance heater as high as possible.

5. Fill radiator and reservoir tank with water and reinstall radiator cap.
• When engine coolant over flows disconnected heater hose, connect heater hose, and continue filling the engine coolant.
6. Connect vacuum hose, and install vacuum tube. Refer to . 7. Install air duct (between air cleaner cover and turbocharger), air cleaner cover assembly and air cleaner body assembly. Refer to EM-26, "Exploded View". 8. Run the engine and warm it up to normal operating temperature. 9. Rev the engine two or three times under no-load. 10. Stop the engine and wait until it cools down. 11. Drain water from the system. Refer to CO-11, "Draining".12. Repeat steps 1 through 9 until clear water begins to drain from radiator.
Was this page helpful?