Front regulator
Exploded View

1. Front door panel
2. Lower sash (front)
3. Sealing screen
4. Pull handle bracket
5. Front door glass run 6. Front door glass
7. Power window motor
8. Front door regulator assembly 9. Lower sash (rear)
: Vehicle fro
Removal and Installation
REMOVAL
1. Remove the front door glass. Refer to GW-17, "Removal and Installation". 2. Disconnect the power window motor harness connector and harness fixing clip. 3. Remove the regulator assembly mounting bolts.4. Remove the regulator assembly from the door panel as shown in the figure.

INSTALLATION
Install in the reverse order of removal.
Disassembly and Assembly
DISASSEMBLY
Remove the power window motor from the regulator assembly.
INSPECTION AFTER REMOVAL
Check the regulator assembly for the following items. Replace or grease it if a malfunction is detected.
• Wire wear
• Regulator deformation
ASSEMBLY
Assemble in the reverse order of disassembly.
Inspection and Adjustment
SYSTEM INITIALIZATION
Initialize the system if any of the following work is complete. Refer to PWC-14, "Description".
FITTING INSPECTION
• Check that the glass is fit securely into the sash groove.• Lower the glass slightly [approximately 10 to 20 mm (0.394 to 0.787 in)], and check that the clearance to the sash is parallel. Loosen the regulator mounting bolts, guide rail mounting bolts, and glass and guide rail mounting bolts to correct the glass position if the clearance between the glass and sash is not parallel.