Heater & Air Conditioning Control System Type 1
Intake sensor
In this manual: Heater & Air Conditioning Control System Type 1
~1min read
Exploded View
• Replace O-rings with new ones. Then apply the compressor oil to them when installing. • Mark the mounting position of intake sensor bracket prior to removal so that the reinstalled sensor can be located in the same position. • Never rotate the bracket insertion part when removing and installing the intake sensor.
Refer to HA-97, "Exploded View (Automatic Air Conditioning)".
Removal and InstallationREMOVAL
1. Remove evaporator assembly. Refer to HA-115, "EVAPORATOR : Removal and Installation".2. Remove intake sensor from evaporator.
INSTALLATION
Note the following items, and then install in the order of removal.
CAUTION:• Replace O-rings with new ones. Then apply the compressor oil to them when installing. • Mark the mounting position of intake sensor bracket prior to removal so that the reinstalled sensor can be located in the same position. • Never rotate the bracket insertion part when removing and installing the intake sensor.
• Check for leakages when recharging refrigerant. Refer to HA-74, "Leak Test".
Was this page helpful?