Engine Lubrication System K9K
Oil filter
In this manual: Engine Lubrication System K9K
~1min read
Exploded View

1. O-ring
2. Oil filter bracket
3. Oil pressure switch
4. Oil filter
5. O-ring
6. Connecting bolt
A. To oil cooler
: N·m (kg-m, ft-lb)
: Always replace after every
disassembly.
Removal and Installation
REMOVAL
1. Using an oil filter wrench [SST:KV113C0010 (Mot.1329)] (A) remove oil filter.
CAUTION:• Be careful not to get burned when the engine and engine oil are hot. • When removing, prepare a shop cloth to absorb any oil leakage or spillage. • Never allow engine oil to adhere to the drive belts.
• Completely wipe off any oil that adhere to the engine and the vehicle.

INSTALLATION
1. Remove foreign materials adhering to the oil filter installation surface.
2. Install oil filter bracket to oil cooler.
CAUTION:Install oil filter bracket, positioning lug in the hole of oil cooler. 3. Apply engine oil to the oil seal contact surface of the new oil filter. 4. Install the oil filter until it comes into contact with the oil seal on the engine bracket. 5. Tighten the oil filter three-quarters of a turn by hand. 6. After warming up the engine, check for engine oil leakage.
7. Check oil level and add engine oil. Refer to LU-33.

Was this page helpful?