Transaxle & transmission 5MT: RS5F92R
Position switch
In this manual: Transaxle & transmission 5MT: RS5F92R
~1min read
Removal and Installation
REMOVAL
1. Drain gear oil. Refer to TM-22, "Draining". 2. Disconnect position switch connector (A).3. Remove position switch from transaxle case.

INSTALLATION
1. Apply recommended sealant to threads of position switch.
• Use Genuine Liquid Gasket, Three Bond 1215 or an equivalent.
CAUTION:Remove old sealant and oil adhering to threads. 2. Install position switch to transaxle case. 3. Tighten position switch to the specified torque. Refer to TM-33, "Exploded View".
4. Refill gear oil. Refer to TM-22, "Refilling".
Inspection
INSPECTION AFTER INSTALLATION
• Check continuity between position switch terminals. Refer to TM-20, "BACK-UP LAMP SWITCH : Component Inspection" (Back-up lamp switch) and TM-20, "PARK/NEUTRAL POSITION (PNP) SWITCH : Component Inspection" (PNP switch).• Check the oil leakage and the oil level. Refer to TM-22, "Inspection".
Was this page helpful?