Defogger
Rear window defogger relay
In this manual: Defogger
~1min read
Description
The rear window defogger is operated by turning the rear window defogger switch ON.
Component Function Check
1.CHECK FUNCTION 1. Perform IPDM E/R Active Test (“REAR DEFOGGER”) using CONSULT-III. 2. Touch “ON”.3. Check that the rear window heating wire is getting warmer.
Is the inspection result normal? YES >> Rear window defogger relay function is OK.
NO >> Refer to DEF-30, "Diagnosis Procedure"
Diagnosis Procedure
1.CHECK FUSE 1. Turn ignition switch OFF.2. Check the 20A fuse (No. 41 located in IPDM E/R).
Is the inspection result normal? YES >> GO TO 2.
NO >> Replace the blown fuse after repairing the affected circuit if a fuse is blown.
2.CHECK IPDM E/R OUTPUT SIGNAL 1. Perform IPDM E/R Active Test (“REAR DEFOGGER”) using CONSULT-III. 2. Touch “ON”.3. Check voltage between IPDM E/R harness connector and ground.

Is the inspection result normal? YES >> INSPECTION END
NO >> Replace IPDM E/R. Refer to PCS-34, "Removal and Installation" (With Intelligent Key system) or PCS-63, "Removal and Installation" (Without Intelligent Key system).
Was this page helpful?